Setting up
24
- ENGLISH
Getting Started
Adjusting the Projector's Height
The projector is equipped with elevator feet for adjusting the image height.
Extend the adjustable feet by rotating in the direction shown in the below picture and retract by rotating in the op-
posite direction.
Adjustable range
Rear adjustable feet :
10 mm (0.394")
Adjustable range
Front adjustable feet :
19 mm (0.748")
The front adjustable feet stretch to its end The rear adjustable feet stretch to its end
2.7 °
6 °
Attention
It is very hot around the lamp and the air exhaust port when the lamp is lighting and for a while after the lamp is turned off.
z
And, hot air is expelled from the air exhaust port when the lamp is lighting. Do not touch there directly when adjusting the
adjustable feet.
Do not stretch the adjustable feet more than the above mentioned length. Otherwise, the projector may be unstable or the
z
adjustable feet may fall off.
To Next Page
Loading...
