Chapter 5 Operations — Network connection
162 - ENGLISH
Network connection
The projector is equipped with the network function, and following is possible by connecting to a computer.
f Web control
Setting, adjustment, and displaying status of the projector are possible by accessing the projector from a
computer.
Refer to “Web control function” (x page 165) for details.
f Smart Projector Control
The application software “Smart Projector Control” can be used, which enables to set and adjust the projector
connected via LAN using a smartphone or tablet.
For details, visit the Panasonic website (https://panasonic.net/cns/projector/).
f Multi Monitoring & Control Software
“Multi Monitoring & Control Software”, a software application to monitor and control multiple display devices
(projector or at panel display) connected to intranet, can be used.
Plug-in software “Early Warning Software”, which monitors the status of the display devices and their peripherals
within an intranet, and noties of abnormality of such equipment and detects the signs of possible abnormality,
can also be used.
For details, visit the Panasonic website (https://panasonic.net/cns/projector/).
f PJLink
Operation or status query of the projector can be performed from a computer using the PJLink protocol.
Refer to “PJLink protocol” (x page 192) for details.
f Art-Net
Setting of the projector can be operated by the DMX controller or application software using the Art-Net protocol.
Refer to “Using Art-Net function” (x page 193) for details.
f Command control
Operation or status query of the projector can be performed from a computer using the control command.
Refer to “Control commands via LAN” (x page 197) for details.
Connecting to the network
This projector can receive the Ethernet signal from the twisted-pair-cable transmitter together with the video and
serial control signal via the LAN cable.
Example of a normal network connection
Computer
Projector
LAN cable (straight) LAN cable (straight)
Hub
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
Note
f A LAN cable is required to use the network function.
f Use a straight or crossover LAN cable that is compatible with CAT5 or higher. Either the straight or the crossover cable, or both cables
can be used depending on the system conguration. Consult your network administrator. The projector will determine the type of the cable
(straight or crossover) automatically.
f Use a LAN cable of 100 m (328'1") or shorter.
To Next Page
Loading...
