Panasonic PT-RZ470EK

Chapter 4 Settings — [PROJECTOR SETUP] menu
78 - ENGLISH
Setting [AUTO POWER SAVE]
Set whether to enable the three functions [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION], and [AV MUTE DETECTION].
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3) Press as to select [AUTO POWER SAVE].
4) Press qw to switch [AUTO POWER SAVE].
f The items will switch each time you press the button.
[ON] Enables power-saving mode.
[OFF] Disables power-saving mode.
5) Press as to select [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION], or [AV MUTE
DETECTION].
[AMBIENT LIGHT
DETECTION]
Adjusts the light source power depending on the brightness of the location of the projector.
[SIGNAL DETECTION] Reduces the power of the light source when there is no signal.
[AV MUTE DETECTION] Reduces the power of the light source in AV mute mode.
6) Press qw to switch the setting of [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION], or [AV MUTE
DETECTION].
f The items will switch each time you press the button.
[ON] Enables the setting.
[OFF] Disables the setting.
Note
f When [AUTO POWER SAVE] is [OFF], [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION], and [AV MUTE DETECTION] cannot be
set.
f [AMBIENT LIGHT DETECTION] cannot be selected when viewing 3D videos. This is xed to [OFF].
Setting [NO SIGNAL SHUT-OFF]
A function that automatically switches the power source of the projector to standby if there is no input signal for a certain period of time. The
time before switching to standby can be set.
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3) Press as to select [NO SIGNAL SHUT-OFF].
4) Press qw to switch [NO SIGNAL SHUT-OFF].
f The items will switch each time you press the button.
[DISABLE] Disables the No signal shut-off function.
[10MIN.] - [90MIN.] Sets the time in 10-minute intervals.
Setting [STANDBY MODE]
Set the power consumption during the standby.
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3) Press as to select [STANDBY MODE].