Panasonic PT-RZ470EK

Chapter 4 Settings — [PROJECTOR SETUP] menu
86 - ENGLISH
Note
f When the Panasonic twisted-pair-cable transmitter (such as the optional digital interface box (Model No.: ET-YFB100G)) is connected to the
projector, its input name is reected from [INPUT1] to [INPUT10] automatically. If an item where the input name is not reected is selected, it
is disabled.
[RS-232C]
Set the sending and receiving port of the serial command.
Communicating using the <SERIAL IN> terminal
1) Press as to select [RS-232C].
2) Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3) Press as to select [INPUT SELECT].
4) Press qw to switch [SERIAL].
5) Press as to select [BAUDRATE].
6) Press qw to switch [BAUDRATE].
f The items will switch each time you press the button.
[9600]
Select the proper speed.[19200]
[38400]
7) Press as to select [PARITY].
8) Press qw to switch [PARITY].
f The items will switch each time you press the button.
[NONE]
Select the parity condition.[EVEN]
[ODD]
Communicating using the <DIGITAL LINK/LAN> terminal
1) Press as to select [RS-232C].
2) Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3) Press as to select [INPUT SELECT].
4) Press qw to switch [DIGITAL LINK].
5) Press as to select [PARITY].
6) Press qw to switch [PARITY].
f The items will switch each time you press the button.
[NONE]
Select the parity condition.[EVEN]
[ODD]
When using existing projector control commands
Set each item when controlling the projector from a computer using control commands of a previously purchased Panasonic projector. Existing
Panasonic projector control software and other software can still be used.
1) Press as to select [RS-232C].