Panasonic PT-RZ770

Chapter 4 Settings — [PROJECTOR SETUP] menu
136 - ENGLISH
[LENS CALIBRATION]
Detect the lens shift limit value of the projector and set the home position and the ET-DLE030 lens standard
position automatically.
1) Press as to select [LENS CALIBRATION].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
Select this item when anything other than the Fixed-focus Lens (Model No.: ET-DLE030) is used.
Move the lens to the home position after completing the calibration.
[DLE030]
Select this item when the Fixed-focus Lens (Model No.: ET-DLE030) is used.
Move the lens to the ET-DLE030 lens standard position after completing the calibration.
3) Press the <ENTER> button.
f The conrmation screen is displayed.
4) Press qw to select [OK], and press the <ENTER> button.
f To cancel, select [CANCEL].
f The lens moves up, down, left, and right to detect the lens shift limit value, and automatically set the home
position and the ET-DLE030 lens standard position.
f The lens stops to complete the calibration.
Note
f [PROGRESS] is displayed in the menu during lens calibration. The operation cannot be canceled during calibration.
f When lens calibration executes correctly, [COMPLETE] is displayed and [INCOMPLETE] is displayed when it does not execute correctly.
f Pressing the <FOCUS> button on the remote control for at least three seconds will also display the conrmation screen for lens calibration
execution.
[STATUS]
Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
3) Press qw to switch the pages.
f The page will change each time you press the button.
[PROJECTOR TYPE] Displays the projector type and serial number of the projector.
[PROJECTOR RUNTIME] Displays the runtime of the projector.
[LIGHT RUNTIME] Displays the runtime of the light source 1 and the light source 2.
[MAIN/SUB VERSION] Displays the main and sub versions of the rmware of the projector.
[INTAKE AIR TEMP.]
*1
Displays the status of the intake air temperature of the projector.
[OPTICS MODULE TEMP.]
*1
Displays the status of the internal temperature of the projector.
[EXHAUST AIR TEMP.]
*1
Displays the status of the exhaust air temperature of the projector.
[LIGHT1 TEMP.]
*1
Displays the light source 1 temperature status of the projector.
[LIGHT2 TEMP.]
*1
Displays the light source 2 temperature status of the projector.
[COOLING CONDITION] Displays the set cooling conditions.
[ATMOSPHERIC PRESSURE] Displays the atmospheric pressure.
[SELF TEST] Displays the status of the projector.
[INPUT] Displays the input terminal currently selected.
[SIGNAL NAME] Displays the input signal name.
[MEMORY NO.] Displays the memory number of the input signal.
[BACKUP INPUT STATUS]
Displays whether switching to the backup input signal is possible or not when [BACKUP INPUT
MODE] is set to [OFF]. (x page 101)
[NUMBER OF REGISTERED
SIGNAL]
Displays the number of registered signals.
[ON COUNT] [POWER ON TIMES] Displays the number of times the power is turned on.
[REMOTE2 STATUS] Displays the control status of the REMOTE2.
[AC VOLTAGE] Displays the input supply voltage.