Panasonic PT-VX415NZ

Status request commands
CommandDescriptionCallback
<Parameter>
QPW
*
Q$S
*
QIN
QAV
QPM
Q$L
Standby power status
Lamp status
Input signal status
Volume adjustment value
Picture mode status
Lamp run time
Standard
Dynamic
Cinema
Real
Blackboard
Colorboard
Image 1
Image 2
Image 3
Image 4
<power condition>
<lamp condition>
<input signal>
<pl>
STD
DYN
CIN
REA
BBD
CBD
IM1
IM2
IM3
IM4
<acctch>
NOTE: If a wrong command is received, the projector will send an ER401 command to the computer.
Command example
To set the volume to +30, send the command as shown below.
STX AVL :30ETX
Start Command Parameter End
NOTE: When sending commands without parameters, a colon (:) is not necessary.
NOTE: If a wrong command is received, the projector will send an ER401 command to the computer.
Parameter format
Parameter format Size (Byte) Definition
<pl>
<off on>
<input signal>
<power condition>
<lamp condition>
<acctch>
3 (1 or 2 bytes also
possible when
under control)
1
3
3
1
4
Decimal without signs: 0 to 999 (000, 001, 002...999)
Decimal with signs: -99 to +99 (-99...-01, +00, +01, +02...+99)
Callback from the projector is 3 Byte.
0 = off, 1 = on
HD1 = HDMI, RG1 = computer 1, RG2 = computer 2, NWP = network
PA1 = memory viewer, MG1 = panasonic application, MV1 = Miracast,
VID = video, SVD = S-Video
000 = power off (standby mode off), 001 = power on (standby mode on)
0 = standby, 1 = lamp on under control, 2 = lamp on,
3 = lamp off under control
Decimal without signs: 0000–9999 hours
*
These commands are effective when the standby mode is set to eco. (Other commands are not effective.)
PT-VX415NZ
LCD Projectors
As of October 2013 12/14
SFL13M008