2. Press RIGHT/LEFT key on the remote control so that the
shaded area moves to the value.
Fig. E2-2
3. Press UP/DOWN key on the remote control to adjust the
value of the selected control.
Fig. E2-3
Note:
You can select a desired channel by using the numbered keys on
the remote control in EVR adjustment mode.
4. Press RIGHT/LEFT key on the remote control so that the
shaded area moves to the control function.
Fig. E2-4
5. Press UP/DOWN key on the remote control to select a
control function for the next adjustment if necessary.
Fig. E2-5
7.3.5.2. How to release from EVR Adjustment Mode:
Press and hold STOP/EJECT, PLAY/REPEAT and VOL- buttons of VCR operation panel on the
unit together over 5 seconds again or press the POWER button OFF to release EVR adjustment
mode. The adjusted value will be written to Memory IC(IC6004).
7.3.6. HOW TO ENTER SERVICE MODE
36
To Next Page
Loading...
