1-8
[SETUP]
Clicking on the [Setup] button displays the [Setup] window. This is where
you select the Serial Ports and the MIDI Channels to be used for transmitting
and receiving data with the DA7.
Selecting the serial port
For Macintosh: Select either the Modem Port or Printer Port
For Windows/95: Select from COM1, COM2, COM3 or COM4 Port
Selecting the MIDI channels (for transmitting and receiving)
Any MIDI Channel 1 through 16 can be selected for Receiving and
Transmitting data. Once you have selected a channel in the upgrade utility
window, you must also check that it is selected to the same channel that has
been set in the [Gen RX] and [Gen TX] fields of the [MIDI>SETUP] Area of
the DA7’s [MIDI>SETUP] window.
To Next Page
Loading...
