19. New feature allows separate IN and OUT X-FADE times of scene
memories
Previous Versions: The FADER IN and OUT times were set to the same
settings.
Version 2.0: The FADER IN and OUT times are Independent and can be
adjusted using the Two soft-knobs in the [SCENE MEMORY>XFADE] window.
20. New feature allows VTR control with RS-422 9-pin protocol
Previous Versions: Only MMC (MIDI Machine Control) was available.
Version 2.0: Now either MMC or VTR control can be selected.
1. Connect a VTR to the RS-422/485 port on the DA7’s Rear Panel.
2. Set the RS422 9PIN PROTOCOL to ON in the [UTILITY>CONFIG]
window.
3. Operate the ARROW buttons on the DA7’s Top Panel in the MMC
mode. Operative buttons are PLAY, FF, REW, and STOP and
LOCATE.
3-16
[SCENE MEMORY>XFADE] window
To Next Page
Loading...
