3-13
15. New feature allows Fader Grouping of the Output Bus Channels
Previous Versions: The Bus Channels could not be included in Fader
Groups.
Version 2.0: The Bus Channels can now be assigned to new Fader Groups 5
and 6. The Bus Channels' Fader Group is assignable in the lower level of the
right side in [GROUP>FADER GRP] window.
To place a Bus into a group, Cursor to [GRP] 5 or 6 by using the UP or
DOWN ARROW button to highlight Group 5 or 6. With the CURSOR in the
CURSOR mode, use the Jog Dial to select the desired Bus channel, or press
the SELECT button of the Bus channel that you wish to place in a group.
The selection of a Bus in a group is represented by a highlighted black box
or “–” mark. The black box means that it is included within the Fader Group,
and the “–” mark means that it is not included within the Fader Group.
Press the ENTER button, then Group 5 or 6 will be toggled. Inverse video
means Enable Fader Group, and normal video means Disable Fader Group.
[GROUP>FADER GRP] window
To Next Page
Loading...
