Panasonic RF-B65

Frequency
Range
2.300-2.495
MHz
3.200-3.400
MHz
3.900-4.000 MHz
4.750-5.060
MHz
5.950-6.200 MHz
7..100-7.300 MHz
9.500-9.900 MHz
1 1 .650-12.050
MHz
13.600-13.800
MHz
15.100- 15.600
MHz
17.550-17.900 MHz
21 .450-21.850 MHz
25.670-26.100
MHz
SW
Meter
Band
120
m
90m
75m
60m
49m
41 m
31 m
25m
21 m
19m
16m
13m
11m
As
there is no Meter Band
Key corres-
ponding
to the 11 meter
band
(SW),
use
the
Frequency Direct
Access Tuning, the
Rotary Tuning,
or the
Up and Down Tuning
mode
to tune to
any station
on
that
band.
I To
set
the
proper
MW
Frequency
Step
(Refer
to the ligure on
page
10.)
The MW frequency
step
in
this unit
is
set
corresponding to the area where
you
purch-
ased
this
unrt. lf
you
use
the
unit
in
the area
where
the frequency
step of
the
broadcasts
is
different,
set the MW Frequency Step Selector
inside
the
Memory
Back-up Battery Compart-
ment to the
proper position.
1.
Remove both all the memory
back-up
batteries and all the radio
batteries.
When
an
AC
power
source has been used,
disconnect
the AC
adaptor.
2.
Set the
MW Frequency
Step Selector to
the
proper position.
3. After about one minute, install the memory
back-up batteries and the radio batteries
and
close the compartment
covers.
Notes:
oWhen
changing the frequency
step, be
sure to remove the
radio
batteries
or
disconnect the AC
adaptor. lf
not, the
received frequency
step
cannot
changed
to the
selected
frequency
step.
.When
re-installing the
memory
back-up
and
radio
batteries or re-connect
the AC
adaptor, be sure to do
after more than
about
one
minute.
.When
the
memory
back-up
batteries
and
the radio batteries
are removed,
the
memories
of
the radio
stations and the
clock times may be lost.
Be
sure to reset
the memories and the
clock times.
I Antennas
(Refer
to
the figures
on
page
11.)
FM/SW:
Pull
out
the Telescopic
Antenna
and adjust
its
length
and angle
for optimum reception.
LWMW:
The
sensitive
ferrite core antenna inside the
set will
provide
excellent
LWMW
reception in
most
areas.
For optimum
reception,
turn the
set in the direction
which
gives
the best
results
since
the ferrite core
antenna
is directional.
Caution
when
adjusting the Telescopic
Antenna
.lf
you
wish to adjust the Telescopic
Antenna,
pull
the
base
of the antenna
and then
pull
the remaining
sections
to
extend
it fully. lf this unit is
positioned
horizontally or
the stand is
used,
you
will
not be able
to adjust the
antenna
unless
the base
has been
pulled
free
of
the set.
oWhen
folding up
the
antenna, first
push
the
base
back
into the
set and then
push
the antenna elements back
together
starting
with the thicker ones.
.External
Antenna
When
the
reception
is
poor
in using with the
Telescopic Antenna,
or when
you
want to
get
more clear
reception, connect the included
External Antenna Cord
to the
External
Anten-
na
Jack.