Panasonic RF-B65

T
Meter Band Direct Access Tuning
(Refer
to the ligures
on
page
17.)
1. Press the Power
On
Key.
2. Press the Meter Band
Direct Access Key.
oThe
band
indicator
(SW)
will begin
flashing.
3. Press the desired
Meter Band
Key.
oThe
lowest frequency of the
meter band
can be called.
4. To tune
in
your
desired station
more
precisely,
use the Rotary
Tuning
or
Up and
Down
Tuning mode.
5. After use, be sure
to
press
the Power Off
Key.
oWhen
you
want to return to
the
previous
display after
pressing
the Meter
Band
Direct
Access
Key,
press
the
key
again.
Note:
After
pressing
the Meter Band Direct
Ac-
cess
Key, if more
than about 10
seconds
is
allowed
to elapse,
a
return
is made to
the
display of
the frequency shown
before
pressing
the
Meter Band Direct Access
Key.
E
Up
and
Down Tuning
(Refer
to
the figures on
page
18.)
1. Press the
Power
On
Key.
.Auto
Scan
Tuning
Pressing for more
than
0.5 seconds
makes
2.
Select
the desired
radio band
by
pressing
the frequency change
rapidly.
lf
you
release
one of
the Band Select Keys
your
finger, the
frequency
will continue
to
change and automatically
stop when broad-
3. Tune
in
your
desired station by using
the casting station
is received.
Up
Key
(n)
and/or
Down Key
(v).
(Referto"Manual
Tuning"and"AutoScan
.To
stop
the Auto Scan before automatic
Tuning" below.)
4. After
use, be sure to
press
the
Power Off
Key.
.Manual
Tuning
Pressing one by one
makes the frequency
change at
the following steps.
stop,
press
the Up or
Down Key.
Notes:
olf
the standby
time has come during
sleep operation,
the sleep timer
is
effec-
tive. ln this case,
the Standby Function
cannot
operate.
olf
a
powerful
station
is received,
the
Auto
Scan
will automatically stop.
But the
receiving
frequency
may
be a little apart
from the correct
frequency.
ln
this case,
set
the Rotary Tuning
Step
Selector
to
"SLOW"
and tune by Rotary
Tuning.
Band
Frequency Step
FM 1 00
kHz
LW 9
kHz
MW
9 kHz
10kHz
SW 5
kHz