Panasonic RX-DT30 - Removal of the Servo P.C.B.

RX-DT30 1
Ref. No. 1
15
~~~ I
Procedure
21,31,7
*15 ,
Removal of the Servo P.C.B.
;
Traverse Unit -
P
Terminals of traverse motor
Terminals of spindle motor
1. Remove 3 screws ( 0 - 0 ).
2. Desolder 2 termrnals of spindle motor.
3. Desolder 2 termrnals of traverse motor.
4. Remove the flexrble cable from
CN701
Removal of the flexrble cable
Push the top of the connector in the
direction of the arrow@, and then
pull out the flexrble cable
in the
directron of the
arrowa.
Note :
Insert a short pin into the flexible cable for
traverse unit.
Ref. No. ’
1
16
Removal of the Traverse Deck Ass’y
Procedure 1
21)31)7 ’
*151,16 :
~~,
1. Widen 2 bosses by using a flat tip screwdriver and remove 2 pins.
2.
Remove the Traverse Deck Ass’y in direction of arrow @follow by ;2,.
Traverse Deck Ass’y
CD OpenSpring
2.
1. Install the CD open spring as shown in above diagram.
3.
-8-
Install the CD cover onto the top cabinet.
Note : When installing the CD cover, make sure the CD cover
IS in half open positron.
Release the
spring in the directton of arrow 0.