RX-DT30
I
n
HOW TO CHECK THE TRAVERSE UNIT
1. Remove the top cabinet
unit.
(Refer to disassembly instructions, Fief No. 3)
2.
Remove
4
screws.
(
0
-
0
)
I
Traverse Unit
3. Set up the traverse unit as shown in diagram.
4. Install the compact disc and disc clamp unit.
Note
:
Before perform checking, make sure the
switch SW401 is switched to “ON” position.
(as shown
in
diagram).
n WHAT TO DO WHEN THE TAPE IS ENTANGLED
When the tape is caught
in
the pitch roller, etc. Release the tape
by turning the pulley on the motor with the screwdriver in the
direction of arrow.
-lO-
To Next Page
Loading...
