Panasonic RX-DT30 - Installing Cassette Compartment; Installing Servo PCB

RX-DT30
n INSTALLING CASSETTE COMPARTMENT
I
,
J /J-Cass. Open Spring
Install the cass. open spring as shown in above diagram.
Cassette Compartment
2. Fix the cassette compartment to front cabinet
Release the spring
INSTALLING SERVO P.C.B.
Before installing the servo P.C.B., move the optical pickup
toward the outer edge from the mark
“A”.
(Otherwise, the rest switch (S701) mounted on the servo
P.C.B may be damaged.)
2. Connect the flexible cable to the connector (CN701).
3. Install the servo P.C.B. in the traverse deck ass’y with
the 3 screws
( 0 - @I ).
4. Solder the 2 terminals of the traverse motor and the
2 terminals of the spindle motor.
Note
: Connect the flexible cable to the connector (CN701)
firmly.
Tighten the screws before soldering the terminals.
__
Spindle motor
-9-