131
5. Select the “Unit no.” by pressing the
or
button and press the button.
The “Exit detailed settings and restart?”
(Detailed setting-end) screen appears on the LCD
display.
Select “YES” and press the
button. When
the setting is completed, perform the test run for
the external static pressure setting described in
“Auto External Static Pressure Setting Operation”.
ALL
20:30 (THU)
NO
Auto External Static Pressure Setting Operation
6. Keep pressing the
, and buttons
simultaneously for 4 or more seconds.
The “Maintenance func” screen appears on the
LCD display.
20:30 (THU)
7. Press the
or button to see each menu.
If you wish to see the next screen instantly, press
the
or button. Select “4. Test run” on
the LCD display and press the
button.
20:30 (THU)
The “Test run” screen appears on the LCD display.
[ ] Confirm
Test run
Change
20:30 (THU)
Test run
OFF
Change the display from “OFF” to “ON” by
pressing the
or button. Then press
the
button.
[ ] Confirm
Test run
Change
20:30 (THU)
Test run
ON
The “Maintenance func” screen appears on the
LCD display.
20:30 (THU)
8. Press the
button. “TEST” will be displayed
on the LCD display.
20:30 (THU)
TEST
9. Press the
button. Test run will be started.
Test run setting mode screen appears on the LCD
display.
FAN SPEED
FLAP
TEST
20:30 (THU)
MODE
10. Set the operation mode to “
(MODE FAN)” and
fan speed mode to “
(FAN SPEED)” by
pressing the
or button or or
button. Then press the button.
FAN SPEED
FLAP
TEST
20:30 (THU)
MODE
FAN
To Next Page
Loading...
