161
2. Mount to the wall.
There are 2 types of wall-mounting methods: Exposed type and Embedded type.
Attention
Mounting the bottom case
Tighten the screws securely until the screw heads touch the bottom case.
(Otherwise, loose screw heads may hit the PCB and cause malfunction when mounting the top case.)
Do not over-tighten the screws.
(The bottom case may be deformed, resulting in the unit becoming detached from the surface it is fixed to.)
Connection to the remote controller terminal board
Depress the push button using a round bar or finger, insert the remote control wiring securely from the wiring
insertion slot and release the push button.
Pull the remote control wiring lightly, and confirm it is secured.
There is the danger of shorting if copper wire is exposed. Make sure the wire is properly inserted.
12.2.3.4 Exposed Type
A protective film is attached on the Control panel.
1
2
2
1
To Next Page
Loading...
