68
11.2.7.3 Remove The Remote Controller
From Tank Unit
1 Remove the top case from the bottom case.
Bottom
case
Flat-blade
screwdriver
Insert the
driver and
slightly turn.
2 Remove the wiring between Remote controller
and Tank Unit terminal.
Disconnect the
Remote controller
wiring
Claw
(2 places)
11.2.7.4 Mounting The Remote
Controller
For exposed type
Preparation: Make 2 holes for screws using a driver.
U
P
Cut here with
a nipper and
remove the burr
withafile.
Mount the top case.
•
Align the claws of the top
caseandthenaligntheclaws
of the bottom case.
Hole for screw
Screw
(field supply)
Claw (2 places)
Pass through
the hole
Bottom case
(Back side)
Top case
(Back side)
Remote controller terminal board
Remove the coating. Approx. 6 mm
Remove the sheath. Approx. 180 mm.
Makesurethewiringconnectionisinthe
correct direction.
Clamper
(field supply)
Claw (2 places)
Wall to which
the remote
controller
fixed
is
Mount the bottom case to
the wall.
Connect the remote control
wiring
•
Arrange the wires along the groove
of the case.
For embedded type
Preparation: Make 2 holes for screws using a driver.
U
P
Avoid the wire
being caught.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Hole for
screw
Screw
(field supply)
Claw (2 places)
Bottom case
(Back side)
Top case
(Back side)
Remote controller
terminal board
Remove the coating.
Approx. 6 mm
Make sure the wiring
connection is in the correct
direction.
Claw (2 places)
Mount the bottom case
to the wall.
•
Pass the wire through the hole
in the centre of the bottom case.
Connect the remote
control wiring
11.2.7.5 Replace The Remote Controller
Cover
Replace the existing Remote controller cover with
Remote controller cover
□
5 to close the hole left
after remove the Remote controller.
1 Release the Remote controller cover’s hooks
from behind the Front Plate ⑯.
Front Plate
⑯
Hook (6 places)
Existing Remote
controller cover
To Next Page
Loading...
