11 Assembly and
disassembly of
Mechanism Unit
11.1. Disassembly Procedure
11.1.1. Disassembly of Traverse Unit
Step 1 Slide the lever (A) in the arrow direction (to the opposite
side) till it stops.
Step 2 Slide the lever (A) further by bending the tab at the right
side of the lever A in the right direction. (The right groove opens
and the boss becomes seen.)
Step 3 Open the lever (B) to left. (The 2 grooves at the left side
open.).
Step 4 Remove the traverse unit.
11.1.2. Disassembly of Tray Unit
Step 1 Slide the guide tray unit while pressing the stopper in
the arrow direction, and remove the guide tray unit.
Step 2 Raise the loading unit.
Step 3 Slide the lever in the arrow direction till it stops and pull
the tray out.
34
SA-HT340EE
To Next Page
Loading...
