Step 2 Hook the lock lever spring on the lock lever projection
part temporarly.
Step 3 Unlock the tab and remove the lock lever.
Step 4 Remove the belt.
Step 5 Unlock the tab and remove the pulley.
Step 6 Remove the relay gear.
Step 7 Turn the change lever in the arrow direction till it stops.
Step 8 Hook the change lever spring on the change lever
project part temporarily.
Step 9 Pull the lever (B) in the bottom side to your side and
remove the change lever.
Step 10 Remove the drive rack, the sub rack and the drive
gear.
36
SA-HT340EE
To Next Page
Loading...
