21.3. Service parts replacement
This document describes additional information during service parts replacement for the mention models. (see behind)
21.3.1. Transmitter Assembly (RFKVHFX60PPS)
This assembly part consists of :
1. Transmitter card
2. Receiver Module P.C.B. (RX).
Refer to Figure 1 for the diagram of transmitter assembly.
Note:
1. This transmitter assembly can be used as a service parts replacement.
2. Below is the service part no. of transmitter assembly for the applied models. (Table 1)
3. The transmitter card consists of the top & bottom cover transmitter module P.C.B. (TX) & screws (x4).
4. The receiver module P.C.B. (RX) in the receiver unit must also be replaced together after replacement of transmitter.
Part No Part Name & Descriptions Applied models Remarks
RFKVHFX60PPS Transmitter Assembly SB-SA640P-S [M]
Table 1
Failure to do so may lead to the disabled of receiver unit due to ID codes mismatched hence no function of wireless surround.
21.3.2. Additional Information
Below is additional information for the system combination.
·
If
is flashing on the main unit after installing the modules P.C.B.. This is due to no link between the main unit & the digital
receiver. (Refer to Table 2 for model no. of digital receiver for applicable models) please check the digital receiver is turned on
& that all installations is carried out properly.
·
If “W01” is flashing or light up re-initialization of the main unit is necessary. Refer to the self diagnostic section for original
service manual of applied models.
Applied models Digital system Transmitter Receiver
SC-HT640WP-S SA-HT640WP-S SH-FX60TPPS SB-SA640P-S
Table 2
100
SA-HT640WP / SA-HT640WPC
To Next Page
Loading...
