1. Load a cassette tape with the erasure prevention tab, remove from
left side only and close the cassette holder.
2. Press “FAST FORWARD” (Tape will be stop after 2 seconds)
3. Load a cassette tape with the erasure prevention tab, remove from
right side only and close the cassette holder.
4. Press “REVERSE” (Tape will be stop after 2 seconds)
5. Load a pre-recorded tape with both side record tabs intact and
close the cassette holder.
6. Press “PLAY” (After TPS function, tape will stop automatically)
7. Press “REC/PAUSE” (Tape will not move)
8. Press “STOP ” to indicate Error code.
- If several problem exist, error code will change each time
when “STOP ” is pressed.
(e.g. H01 H02 H03 .....etc.)
9.4. To clear all Error code
1. Press “STOP/TUNE MODE” button for 5 seconds.
2. FL indicator shows “CLEAR” for 1 second and change to “T”.
9.5. How to get out from Self-Diagnostic function
1. Press “Power” button OFF.
9.6. Power Amplifier Failure (F61)
1. When power amplifier fail, F61 will indicate automatically.
10. Description of Error Code
10.1. Error detection for Cassette Mechanism block
26
To Next Page
Loading...
