AM Loop antenna
4. Self-Diagnostic Display Function
This unit is equipped with a self-diagnostic display function, which will be useful during servicing
and maintenance.
- Refer to the next page for display symbols, symptoms, etc.
4.1. Preparations
1. A Cr02-positioned blank cassette tape with an erase prevention
niche on either Side A or B.
2. A normal-positioned music tape with erase prevention niches on
both Sides A and B. Both tapes are halfway forwarded in advance.
3. The remote controller that comes with this unit.
4.2. Entering Self-Diagnostic Mode
1. Press [CD / ] button on the unit with no MD, CD or cassette
tape inserted. (The power must be turned on.)
2. Press and hold down [STOP ] button and then press [ / /
FF] button together for 2 seconds or more.
3. When [STOP ] button is released, the message, “TEXT” appears
on the display. (Cf. Fig. 1)
4.3. Restoring Normal Display
- From the F76 display, the normal display does not appear till an
error is recovered.
- For displays other than F76, press “POWER” button to turn off the
power, and then turn on the power.
5
To Next Page
Loading...
