Caution Note: Keep the AC Inlet shield plate unit in safe
place. Avoid denting it. Place it back during assembling.
Step 4 Remove the D-Amp P.C.B. bracket.
Step 5 Remove AC Inlet P.C.B.
Caution Note: Keep the D-Amp P.C.B. bracket in safe
place. Avoid denting it. Place it back during assembling.
Special Note: During reassembling procedures, ensure the
P.C.B. is seated properly at the locators.
7.14. Disassembly of Main P.C.B.
•
• •
• Follow (Step 1) to (Step 3) of Item 7.3.
Step 1 Remove 3 screws at the rear panel.
Step 2 Remove3screwsonMainP.C.B.
Step 3 Detach 17P FFC cable at the connector (CN2007) on
the Main P.C.B.
Step 4 Detach 4P FFC cable at the connector (CN2013) on the
Main P.C.B.
Step 5 Detach 13P cable at the connector (CN2016) on the
Power Supply P.C.B.
Step 6 Detach 28P cable at the connector (CN6001) on the
Power Supply P.C.B.
Step 7 Detach 12P cable at the connector (CN7000) on the Mic
P.C.B.
Step 8 Detach Main P.C.B. from the rear panel.
Step 9 Turn over Main P.C.B. to detach 17P FFC cable at the
connector (CN2009) on the Main P.C.B.
Step 10 Detach 50P FFC cable at the connector (CN2001) on
the Main P.C.B.
Step 11 Detach 22P FFC cable at the connector (CN2801) on
the Main P.C.B.
Step 12 Remove Main P.C.B.
23
SA-PT465EE
To Next Page
Loading...
