Step 1 Desolder pins of the switch regulator IC (IC5701) on the
reverse side of SMPS P.C.B.
Step 2 Remove 1 screw from the switch regulator IC (IC5701).
Step 3 Remove the switch regulator IC (IC5701) from the
heatsink unit B.
Caution: Handle the heatsink unit B with caution due to its
high temperature after prolonged use. Touching it may
lead to injuries.
Note : Refer to the diagrams of SMPS P.C.B. (Item 8.5.) for
location of the part.
7.21.1. Assembly of Switch Regulator IC
(IC5701)
Step 1 Apply grease to the heatsink unit B.
Step 2 Fix and screw the switch regulator IC (IC5701) to the
heatsink unit B.
Special Note: Ensure the switch regulator IC (IC5701) is tightly
screwed to the heatsink unit B.
Step 3 Solder pins of the switch regulator IC (IC5701) on the
reverse side of SMPS P.C.B.
Special Note: Ensure pins of the switch regulator IC (IC5701)
are properly seated and soldered on SMPS P.C.B.
7.22. Replacement of Switch
Regulator Diode (D5702)
•
• •
• Follow (Step 1) to (Step 3) of Item 7.3.
•
• •
• Follow (Step 1) to (Step 7) of Item 7.14.
•
• •
• Follow (Step 1) to (Step 6) of Item 7.20.
Step 1 Desolder pins of the switch regulator diode (D5702) on
the reverse side of SMPS P.C.B.
Step 2 Desolder pins of the heatsink unit B.
31
SA-PT465EE
To Next Page
Loading...
