Panasonic SA-PT465EE

Step 3 Solder pins of the regulator IC (IC2903) on the reverse
side of Power Supply P.C.B.
Step 4 Solder pins of the hestsink extrussion on the reverse
side of Power Supply P.C.B.
Special Note: Ensure pins of the regulator IC (IC2903) are
properly seated and soldered on Power Supply P.C.B.
7.28. Disassembly of DVD Module
P.C.B.
•
• •
• Follow (Step 1) to (Step 3) of Item 7.3.
•
• •
• Follow (Step 1) to (Step 8) of Item 7.14.
Step 1 Detach 50P FFC cable at the connector (CN2001) on
Main P.C.B.
Step 2 Move aside Main P.C.B. and position it according to the
diagram shown.
•
• •
• Disassembly at HDMI Shield Plate Unit
Step 3 Remove 2 screws from the HDMI shield plate unit.
Step 4 Remove the HDMI shield plate unit.
Caution Note: Keep the HDMI shield plate unit in safe
place. Avoid denting it. Place it back during assembling.
Step 5 Detach 7P cable at the connector (FP8251) on DVD
Module P.C.B.
Step 6 Detach 26P cable at the connector (FP8531) on DVD
Module P.C.B.
Step 7 Detach 5P cable at the connector (FP9001) on DVD
Module P.C.B.
37
SA-PT465EE