Panasonic SB-FS730

10.1.2. Service Mode
(Service Mode and Service Data)
Number Details Meaning at Minute Position
(Service Data 1)
Meaning of Second Position
(Service Data 2)
Note
0 Service data VCR mode
(real time)
Processing number
(real time)
Deck mode Treatment during mechanism transition
Control number
1 Service data Starting/End terminal detect information Reception key information Displayed only
when the
reception key
button is ON.
00 : Detection of neither starting or end terminal
01 : Detecting starting terminal
02 : Detecting end terminal
03 : Detecting both starting and end terminals
When the unit key or remote controller
unit is used, the reception code is
displayed.
2 Service data Mechanical position
(real time)
Motor command
(real time)
Because the
mechanical
operation is
available without
a tape, this
mode accepts:
No starting/end
terminal
detection
No reel lock
detection
No judgment of
tape quality and
no position
detection
0L : EJECT position
02 : DOWN positions
03 : R-REW positions
04 : LOAD positions
05 : REV positions
06 : PLAY positions
07 : POFF positions
08 : STOP positions
09 : STOP positions
0- : FFREW positions
0_ : Middle of positions
0*, 2* : CYL off
Cap off
1* : CYL off
Cap on (fwd)
3* : CYL off
Cap ON (rev)
8*, U* : CYL on
Cap off
9* : CYL on
Cap on (fwd)
A* : CYL on
Cap ON (rev)
*0 : Moter off
*1 : Loading
*2 : Un Loading
*3 : Break
(Load + Unload)
3 Self diagnosis history
(1st time)
Error code of History 1 Additional information 1 and 2 of History
1
4 Self diagnosis history
(2nd time)
Error code of History 2 Additional information 1 and 2 of History
2
5 Self diagnosis history
(3rd time)
Error code of History 3 Additional information 1 and 2 of History
3
6 Service data Cylinder ON command Cap motor ON/OFF and forward/reverse
rotation command
Same as the
details
numbered as 5
and 6 of
previous service
mode.
7 Manual operation Real time Mechanical position Real time Motor command PLAY button
ON: loading
direction
STOP button
ON: Unloading
direction
Same as the details of Service 2 Same as the details of Service 2
10.1.3. Service Mode Display
(Overview)
A part of the microcomputer internal information is displayed on the FL in order to ease servicing during sales.
(Setting)
Press and hold down the FF and EJECT buttons for at least three seconds to enter the service mode. As this operation is
repeated, service number changes starting at 0 up to 7, and then counter (clock) is displayed.
(Display)
FL display example:
15
SA-HT833VP