Panasonic SC-ALL9

SQT1211
15
Bluetooth
®
operations
By using the Bluetooth
®
connection, you can
listen to the sound of the Bluetooth
®
audio
device wirelessly.
≥ Refer to the operating instructions of the
Bluetooth
®
device for further instruction on
how to connect a Bluetooth
®
device.
Preparation
≥ Turn on the Bluetooth
®
feature of the device
and place the device near this unit.
∫ Bluetooth
®
pairing
1 Touch [ ].
≥ If the Bluetooth
®
indicator (blue) blinks fast, go to
step 3.
2 To enter pairing mode, touch and
hold [ ] for at least 2 seconds.
≥ The Bluetooth
®
indicator (blue) blinks faster.
3 Select “SC-ALL9” or “SC-ALL6”
from the Bluetooth
®
device’s menu.
≥ The MAC address “” (“” stands for a
character that is unique to each set.) may be
displayed before “SC-ALL9” or “SC-ALL6” is
displayed.
≥ The Bluetooth
®
indicator (blue) lights up and the
device is connected to this unit.
∫ Connecting a paired Bluetooth
®
device
1 Touch [ ].
≥ The Bluetooth
®
indicator (blue) blinks slowly.
≥ If the Bluetooth
®
indicator (blue) lights, a Bluetooth
®
device is already connected with this unit.
Disconnect it. (l right)
2 Select “SC-ALL9” or “SC-ALL6”
from the Bluetooth
®
device’s menu.
3 Start playback on the Bluetooth
®
device.
∫ Disconnecting a Bluetooth
®
device
Touch and hold [ ] for at least 2 seconds.
≥ The Bluetooth
®
indicator (blue) blinks slowly.

≥ If prompted for the passkey, input “0000”.
≥ You can register up to 8 devices with this unit. If a 9th
device is paired, the device that has not been used for
the longest time will be replaced.
≥ When [ ] is selected as the source, this unit will
automatically try and connect to the last connected
Bluetooth
®
device. If the connection attempt fails, try to
establish a connection again.
≥ When the unit is selected as the speakers powered by
AllPlay, the audio source will change to the network.
≥ Bluetooth
®
cannot be selected as the audio source when
the unit is waiting for the WPS PUSH or WPS PIN code
connection.
≥ This unit can only be connected to one device at a time.
≥ When enjoying video contents with this function, the
video and audio output may not be synchronised.
This function allows you to connect a paired
Bluetooth
®
device when this unit is in standby
mode.
≥ This unit will be turned on automatically when
you connect a paired Bluetooth
®
device.
– If this function is set to “On”, the standby power
consumption will increase.
Touch and hold [ ] and [1] for at least
4 seconds.
The mode indicator blinks once.
Bluetooth
®
Stand-by is “On”.
The mode indicator blinks twice.
Bluetooth
®
Stand-by is “Off”.

≥ You can not set this function during the network indicator
blinking in blue and red.
≥ The factory default is “Off”.
Connecting via Bluetooth
®
menu
Bluetooth
®
standby
SC-ALL9&6-SQT1211_mst.book 15 ページ ２０１６年１月１２日 火曜日 午後３時１６分