Panasonic SC-ALL9

SQT1211
19
Others
As a factory default, there will be a beep sound
when you touch the switch on the unit.
∫ To cancel this function
Touch and hold [1] and [2] for at least
4 seconds.
≥ The mode indicator (amber) blinks twice.

≥ To turn the function on, perform the same operation as
the above.
(The mode indicator blinks once.)
To check the Wi-Fi signal strength where the
unit is located.
Touch and hold [NET] and [2] for at
least 4 seconds.
≥ The mode indicator (amber) blinks once and then blinks
again to show the Wi-Fi signal strength.

≥ If the network indicator is blinking in blue and red, wait
until the blinking stops.
≥ If the Wi-Fi signal strength cannot be checked, deselect
the unit from speakers powered by AllPlay, and try again.
To check the unit’s IP address and the MAC
address.
Preparation
≥ Download the app “Panasonic Music
Streaming”. (l 11)
1 Start the app “Panasonic Music
Streaming”.
2 From “Speaker”, select “ ”.
3 Select this unit.

≥ This unit will be displayed as “Panasonic ALL9” or
”Panasonic ALL6” if the device name is not set.
≥ If the network indicator is blinking in blue and red, wait
until the blinking stops.
Operation sound setting
Wi-Fi signal strength
Number of blinks Wi-Fi signal strength
0
1
2
3
Weak
Strong
IP/MAC address
SC-ALL9&6-SQT1211_mst.book 19 ページ ２０１６年１月１２日 火曜日 午後３時１６分