Panasonic SC-ALL9

SQT1211
17
[SC-ALL6]
Rear surround
If you have a compatible Panasonic Home
Theater Audio System (e.g. SC-ALL70T/
SC-ALL30T), you can use two SC-ALL6 units as
rear surround speakers to enjoy surround
speaker sound.
≥ Refer to the operating instructions for your compatible
Panasonic Home Theater Audio System.
Preparation
≥ Turn SC-ALL6 and SC-ALL70T/SC-ALL30T
on.
1 Start the pairing mode on
SC-ALL70T/SC-ALL30T.
2 Touch [REAR MODE] on each
SC-ALL6.
≥ The network indicator goes off. (Except when it is
blinking alternately in red and blue)
≥ The rear surround indicator (green) starts to blink
slowly.
3 Touch and hold [REAR MODE] for at
least 4 seconds.
≥ The rear surround indicator (green) starts to blink.
4 Touch [1] and [REAR MODE] for at
least 4 seconds on one SC-ALL6 as
left surround speaker.
≥ The rear surround indicator (green) blinks faster and
lights up when pairing is successful.
5 Touch [2] and [REAR MODE] for at
least 4 seconds on the other
SC-ALL6 as right surround speaker.
≥ The rear surround indicator (blue) blinks faster and
lights up when pairing is successful.

≥ The pairing mode is cancelled after about 2 minutes
elapses. You can also touch [Í/I] to cancel it.
≥ When this unit is in rear surround mode, turning the
paired SC-ALL70T/SC-ALL30T on/off will automatically
turn this unit on/off.
≥ The below functions may not be available when this unit
is paired as rear surround speaker.
– Streaming music by network
– Adjusting volume with this unit
≥ You cannot adjust the delay time with this unit.
≥ If you try to set left and right surround speakers to the
same channel on SC-ALL6, pairing fails.
≥ If pairing fails, the rear surround indicator starts to blink
slowly.
Repeat the procedure from the beginning if this occurs.
Pairing
SC-ALL70T/SC-ALL30T
SC-ALL6SC-ALL6
Surround R chSurround L ch
SC-ALL9&6-SQT1211_mst.book 17 ページ ２０１６年１月１２日 火曜日 午後３時１６分