Panasonic SC-ALL9

16
SQT1211
You can change the transmission mode to
prioritise transmission quality or sound quality.
Preparation
≥ Touch [ ].
≥ If a Bluetooth
®
device is already connected,
disconnect it.
Touch and hold [ ] and [2] for at least
4 seconds.
The mode indicator blinks once.
Mode1 (Emphasis on connectivity)
The mode indicator blinks twice.
Mode2 (Emphasis on sound quality)

≥ You can not set this function during the network indicator
blinking in blue and red.
≥ Select “Mode1” if the sound is interrupted.
≥ The factory default is “Mode2”.
If the sound input level from the Bluetooth
®
device is too low, change the input level setting.
Preparation
≥ Make sure that a Bluetooth
®
device is already
connected with this unit. (l 15)
Touch and hold [ ] and [VOL –] for at
least 4 seconds.
≥ The mode indicator (amber) blinks to show the
Bluetooth
®
input level.

≥ You can not set this function during the network indicator
blinking in blue and red.
≥ Select “Low” if the sound is distorted.
≥ The factory default is “Low”.
AUX input
You can also listen to music from an external
music player through this unit.
Preparation
≥ Connect an external device. (l 6)
1Touch [AUX].
≥ The AUX indicator lights up.
2 Start playback on the connected
device.
∫ To select the sound input level of the
external device
While in AUX mode, touch and hold [AUX]
for at least 4 seconds.
The mode indicator blinks once.
Normal level
The mode indicator blinks twice.
High level
≥ The factory default is “Normal level”.

≥ You can not set this function during the network indicator
blinking in blue and red.
≥ To improve sound distortion when “High level” is
selected, select “Normal level”.
≥ Turn the volume of the external device down to reduce
the input signal. High level of input signal will distort the
sound.
≥ For details, refer to the operating instructions of the
device.
≥ When the unit is selected as the speakers powered by
AllPlay, the audio source will change to the network.
≥ AUX cannot be selected as the audio source when the
unit is waiting for the WPS PUSH or WPS PIN code
connection.
Bluetooth
®
transmission
mode
Bluetooth
®
input level
Number of blinks Bluetooth
®
input
level
1
2
3
Low
High
SC-ALL9&6-SQT1211_mst.book 16 ページ ２０１６年１月１２日 火曜日 午後３時１６分