8
SQT1211
≥ The following steps are based on a
smartphone.
≥ Do not connect a LAN cable. Doing so will
disable the Wi-Fi function.
1 Turn this unit on.
2 Go to Wi-Fi settings on the device.
≥ Proceed to the next step after the network indicator
changes from blinking in blue and red to blinking
slowly in blue
§
.
§ The blinking in blue starts after approximately
1 minute. If the blinking in blue does not start,
perform a network reset. (l 9)
3 Select “AllPlay _AJ” to
connect to this unit.
≥ “” stands for a character that is unique to each set.
≥ This can take up to 1 minute to appear in your Wi-Fi
list.
≥ If this operation does not work correctly, please
repeat it several times.
≥ Make sure that DHCP is enabled for the network
setting on your compatible device.
[iOS_device]: The settings page will be automatically
displayed in the Internet browser.
[Except_iOS_device]: Open the Internet browser and
refresh the page to display the settings page.
≥ If the settings page is not displayed, type “http://
172.19.42.1/” into the URL address field.
4 Type a device name and then select
“Next”.
≥ The device name will be displayed as this unit’s
name on the network.
≥ The guaranteed limit is 32 characters.
≥ The device name is set when “Next” is selected.
≥ You can also change the device name after the
network connection is set up. (l 10)
5 Select your network name (SSID)
and type the password.
≥ Check the wireless router for the network name
(SSID) and the password.
≥ A list of network names (SSIDs) will be appeared
when you select the “Network Name” box.
≥ To show the characters typed in the “Password”
box, select “Show Password”.
≥ If your network requires specific settings, deselect
“DHCP” to disable DHCP.
– You can use specific IP address, subnet mask,
default gateway, primary DNS, etc.
≥ To update the network name (SSID) list, select
“Refresh list”.
6 Select “Connect” to apply the
settings.
≥ When the connection is established, the network
indicator (blue) lights up.
≥ Depending on the device, the connection complete
screen may not be displayed.
7 Make sure to connect your
compatible device back to your
home wireless network.
≥ Enable Java and cookies in your browser settings.
Using an Internet browser
AllPlay
If the network indicator does not light up,
check the network name (SSID) and the
password, and then try the setting again.
*
Network Name
Refresh list
*
Password
Show Password
DHCP
●●●●●●●●
SC-ALL9&6-SQT1211_mst.book 8 ページ ２０１６年１月１２日 火曜日 午後３時１６分
To Next Page
Loading...
