RQTX1190
ENGLISHENGLISH
44
Preparing the remote control
Use alkaline or manganese batteries.
Insert so the poles (+ and –) match those in the remote
control.
Aim at the remote control signal sensor (Z page 5),
avoiding obstacles, at a maximum range of 7 m directly in
front of the unit.
Note on using the remote control
• Do not mix old and new batteries.
• Do not use different types of batteries at the same time.
• Do not take apart or short circuit the batteries.
• Do not attempt to recharge alkaline or manganese
batteries.
• Do not use batteries if the covering has been peeled off.
• Do not heat or expose to fl ame.
• Do not leave the battery(ies) in an automobile exposed
to direct sunlight for a long period of time with doors and
windows closed.
• Mishandling of batteries in the remote control can cause
electrolyte leakage, which may cause a fi re.
• Remove the batteries if the remote control is not going
to be used for a long period of time. Store in a cool, dark
place.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of
used batteries according to the manufacturer’s
instructions.
R6/LR6, AA
(not included)
Placement of speakers
Speakers are designed identically so that no left or right
channel orientation is necessary.
You cannot take the front net off the speakers.
Use only the supplied speakers
Using other speakers can damage the unit and sound
quality will be negatively affected.
• Keep your speakers at least 10mm away from the
system for proper ventilation.
• These speakers do not have magnetic shielding. Do
not place them near televisions, personal computers or
other devices easily infl uenced by magnetism.
• You can damage your speakers and shorten their
useful life if you play sound at high levels over extended
periods.
• Reduce the volume in the following cases to avoid
damage.
– When playing distorted sound.
– When adjusting the sound quality.
Caution
• Use the speakers only with the recommended
system. Failure to do so can damage the
amplifi er and speakers, and can cause fi re.
Consult a qualifi ed service person if damage
occurs or if a sudden change in performance is
apparent.
• Do not attach these speakers to walls or ceilings.
Making the connections
(6:)
(6:)
1
2
3
4
A
B
B
A
1 Connect the speakers.
Be careful not to cross
(short-circuit) or reverse
the polarity of the speaker
wires as doing so may
damage the speakers.
2 Connect the AM loop antenna.
Stand the antenna up on its base.
3 Connect the FM indoor antenna.
Place the antenna where reception is best.
4 Connect the AC mains lead.
The included AC mains lead is for use with this unit
only. Do not use it with other equipment.
Do not use an AC mains lead from other equipments.
Black
Red
Click!
To household
mains socket
4
PM02EP_EN.indd 4PM02EP_EN.indd 4 6/28/2010 12:22:43 PM6/28/2010 12:22:43 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
