ENGLISH
RQTX0190
11
Press [DISPLAY] to select the display.
The information scroll through the display.
Each time you press the button:
Dynamic label
(information about the
broadcast)
PTY display
(program type)
Ensemble label
(the name of the
ensemble)
Frequency display
Time display
Press the [DAB SECONDARY] to select the
secondary service.
“ ”
is displayed if there is a secondary service broadcast.
The secondary services are selected each time the
button is pressed. The primary service is returned to
after the last secondary service.
To adjust the time information during DAB broadcasting
and automatic time adjustment.
1 Press [DAB MENU] to enter menu mode.
2 Within 10 seconds, press [e,r] to select
“AUTO CLOCK ADJ.” and then press [OK].
3 Within 10 seconds, press [e,r] to select
“ON ADJUST” and then press [OK].
Select “OFF ADJUST” to turn the automatic clock
adjustment function off.
To exit
Press [DAB MENU] again.
Presetting
Turning automatic clock
adjustment function on
To improve reception by adjusting the antenna while
monitoring signal quality on the display.
1 Press [DAB MENU] to enter menu mode.
“SCAN FAILED.” appears if no stations are
memorized. If this occurs, adjust the antenna and try
Auto scanning or change the Auto scan frequency
range. (➡ page 12)
2 Within 10 seconds, press [e,r] to select
“SIGNAL QUALITY” and then press [OK].
3 Press [e,r] to select the frequency.
To exit
Press [DAB MENU] again.
In order to enjoy the new stations after adjusting the
antenna, it is necessary to perform Auto scanning and
update the station memory.
DAB (continued)
Listening to the secondary service
Display
Note
Note
Frequency
block
Frequency
Reception quality
0 (poor) - 8 (excellent)
Checking the DAB signal quality
Up to 20 channels can be set.
1 Press [u/t] or [y/i] to select a station.
2 Press [PROGRAM].
3 Press the numeric buttons to select a channel.
4 To preset more stations, press [PLAY MODE] to
select “STATION TUNE” and then repeat steps 1
to 3.
You cannot preset stations when the station is not
broadcasting or when you are selecting a secondary
service.
1 Press [PLAY MODE] to select “PRESET TUNE”.
2 Press [u/t] or [y/i] or numeric buttons
to select a channel.
Note
Selecting a preset channel
Presetting channel
SC-PM42DBEB.indb 11 1/6/2010 10:14:38 AM
To Next Page
Loading...
Need help?
General
