Panasonic SD-YD250 - 2.3. Bottom Plate and Body Disassembly

5. Pull out and disconnect the connector on the circuit board. (Fig.11
)
Removal of Positive Lock connector
The positive lock connector is a specialty designed loose connector. / To remove this
connector, pull the lead wire by pressing an extruded lever in the center of receptance terminal.
6. Remove the screw.
7. Remove the PCB holder assembly. (Fig.11)
Fig.11
No.
Parts Name
1 Angle
2 Screw
3 PCB-(B)
4 PCB holder
2.3. Bottom plate, and body Disassembly
Note:
Please detach Control panel and Top lid to the start, and remove the connector connection of
lead wires.
1. Remove the six screws which secure the heater case from the
sides. (Fig.8)
Fig.8
11