No.
Parts Name
1 Screw(for Yeast dispenser)
2 Screw(for Lever)
3 Steam vent (Yeast dispenser)
4 Lever
5 Yeast dispenser chute
2.9. Heater
1. Remove the two heater terminal disconnect.
2. Press the heater bobbin B (two) from outside the heater case.
(Fig.17)
Fig.17
No.
Parts Name
1 Three tabs
2 Angle
3 Heater bobbin B
3. Remove the screw which secure heater bobbin A and remove the
heater. / Assembly instruction: Reset the three tabs.
2.10. Belt, Pulley and Connector lower (Fig.16)
1. Remove the belt.
2. Remove the nut and the pulley B.
3. Remove the U-ring and pull out the connector (lower) from the
heater case side.
Fig.18
16
To Next Page
Loading...
