No.
Parts Name
1 Heater case
2 Angle
3 Connector (lower)
4 Heater case base
5 Pully B (for 5 ribs Belt)
6 Motor washer A
7 U-ring
8 Lock washer
9 Nut
10 Belt (5 ribs/wide type)
Note:
Belt, Pully B and Pully A(with motor) of this model use a wide type to improve the durability of
the belt. / There is no interchangeability mutual with parts of the previous models. / Please note
that never making a mistake in the use of eachpart, when exchange parts.
2.11. Heater case base
1. Belt and Pully B are detached beforehand.
Assembly instruction: / The position of each Set Mark must be
matched.
2. Remove the four screws which secure the heater case base, and
remove the heater case base. (Fig.19)
Fig.19
17
To Next Page
Loading...
