36
VQT3E89
This unit will resume recording pause mode
about 0.8 seconds after the LCD monitor is
reopened.
¬ Change the mode to .
1 Select the menu. (l 23)
2 Close the LCD monitor while
the mode is set to .
The status indicator A flashes green and the
unit goes into quick start standby mode.
3 Open the LCD monitor.
The status indicator A lights red and the unit
is put into recording pause.
≥ When in quick start standby mode
about 70% of the power used in
recording pause mode is being
consumed, so the recording time will
be reduced.
≥ Quick start standby mode is cancelled if
jabout 5 minutes elapsed
jmode is set to
≥ It may take some time for automatic white
balance to adjust.
≥ In the quick start mode, the zoom
magnification becomes 1k.
≥ If [ECONOMY] (l 25) is set to
[5 MINUTES] and the unit automatically
goes into quick start standby mode, close
the LCD monitor and then open it again.
≥ Turn the unit off using the power button.
Quick start
[SETUP] # [QUICK START] # [ON]
SDRS71&H101GN-VQT3E89_mst.book 36 ページ ２０１０年１２月２日 木曜日 午後３時３５分
To Next Page
Loading...
