Panasonic SF4C Series - Page 35

35
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
English
4. Device Placement
● This is the conguration when two or more sets of emitter and receiver facing each other are placed.
● It is used for system evaluation in case of addition of equipment.
WARNING
● Refer to the examples of device placement given below and understand them thorough-
ly before installing the devices. Improper sensor placement could cause device malfunc-
tion, which can result in death or serious injury.
● If this device is used in multiple sets, arrange them to avoid mutual interference. If mu-
tual interference occurs, it can result in death or serious injury.
● When using this device in Korea with S-mark, be sure to ground to 0V side (PNP output).
<Example of device placement>
1) Install the emitter and the receiver back to back 2) Arrange the emitter and the receiver vertically on
opposite sides.
Receiver Emitter Emitter Receiver
Receiver
Emitter
Emitter
Receiver
3) Arrange the emitter and the receiver horizontally on
opposite sides.
4) Install a barrier
Receiver
Emitter
Emitter
Receiver
Receiver Emitter EmitterReceiver
Barrier
The above figures are just examples of device placement. If there are any questions or problems,
please contact our ofce.
WARNING
Position the emitter and receiver so that
their cables are aligned. Failure to do so
will cause the system to malfunction.
Cable
Cable
Cable
Cable
<Reference>