Watching TV
Antenna / Cable service without a box
Initial setting
1. Connect coax
Connect a COAX wire from either an antenna or Basic Cable service to the
TV's "ANTENNA/CABLE IN" screw terminal.
TV (ANTENNA/CABLE IN)
Antenna
2. Scan the channel
I MENU] -_ >: : : > : : >
1. Select either Cable or Antenna programming source in
2. Select and then the appropriate scan mode:
( / / ; _).
3. Start scanning.
If no channels are found by the end of the scan, then check the
following:
Antenna's position - or availability of Cable service.
Cable, Satellite or Fiber services with a box are typically connected to
the TV's AN inputs, preferably HDMI, for best HD picture. In such a
case, the channel scanning is not needed.
16 (0100301)
To Next Page
Loading...
