Watching TV
3D
Registration
• First reaistration
w
Perform the first registration when the 3D Eyewear is used for the first time.
1. Turn the TV on
2. Press the button for about 1 second to turn the power on.
The lamp lights for about 2 seconds and then flashes.
The 3D Eyewear will be turned on and start registration.
Place the 3D Eyewear within 1.6 ft (50 cm) from the TV while
registration in progress.
3. When the registration is successfully completed, the 3D Eyewear
will reconnect with TV automatically when 3D Eyewear is turned
on near the TV in 3D mode.
• Registration again
When connection with registered TV fails, or when using with another TV,
re-register the 3D Eyewear.
1. Turn the "rv on
2. Within 1.6 ft (50 cm) from the TV, press Power button until lamp
lights, then release it to start registration.
3. When the registration is successfully completed, the 3D Eyewear
will reconnect with TV automatically when 3D Eyewear is turned
on near the TV in 3D mode.
° If the registration failed, the 3D Eyewear will power off.
In this case, power off the TV and perform from step 1.
48 (0100806)
To Next Page
Loading...
