Panasonic TC-L32C3

TC-L32C3
30
8 Measurements and Adjustments
8.1. Voltage chart of A-board
Check +B voltage of A PCB
8.2. Voltage chart of P-board
Check +B voltage of P PCB
8.3. Picture level adjustment (RF)
VOLTAGE TEST POINT SPECIFICATION
(Reception state)
STB3.3V TP4716 3.3 ± 0.16 V
SUB5V TP4723 5.1 ± 0.25 V
AVDD12.5V TP7019 12.5 ± 2 V
TCON2.5V TP7021 2.5 ± 0.12 V
TCON31V TP7013 31 ± 3.1 V
TCON-6V TP7014 -5.7 ± 0.6 V
VOLTAGE TEST POINT SPECIFICATION STATE
PFC390V +TP7201, 7202 390 ± 15 Reception * HOT
-TP7203, 7204 - - * HOT
DTV16V TP7801, 7505 15.6 ± 1.5 Reception
STBY6V TP7506
5.8 ± 0.8 Reception
5.8 ± 0.8 Stand by
Instrument Name Remarks
1. REMOTE TRANSMITTER
2. Ex. Signal (Sprit color bar)
Adjustment or Inspection Procedure Remarks
procedure
1. Receive the Sprit color bar.
(Screen mode: ZOOM or FULL Picture mode: DYNAMIC AI: OFF AI Picture: OFF)
*BACK LIGHT +30
Inspection
1. Enter Service mode, and select MAIN_ADJ PICTURE.
Volume UP/DOWN key makes GAIN displayed under PICTURE to set.
Pushing the remote controller [OK] key for about 3 seconds, GAIN is suited
to the adjustment value automatically.
(The Sprit Color Bar Pattern)