Troubleshooting 7 Blinks Failure (TC-P50ST50)
Is the power
LED blinking 7
or 8 times?
8 Times
7 Times
Check the wires between connector P2 on the P board and
SC2 on the SC board. Make sure they are properly seated. If
the problem persists, unplug the TV and remove connector
SS11 from the SS board. Plug-in the TV and turn it on.
Start Here
List of boards likely to cause this symptom. Blink
Code
No.1 No.2 No.3 No.4 No. 5 No. 6
SU SC SS A Panel 7
Blinks
SD
Is the power
LED blinking 7
or 8 times?
7 Times
8 Times
Unplug the TV and reconnect SS11.
Remove SC20 from the SC board.
Plug-in the TV and turn it on.
Unplug the TV. Reconnect SC20
and follow step #1 of the next slide.
Replace the SS
board
Replace the A
board
Continue on the page after next
Slide 19
Find information for TC-P50UT50 on slides 23~26
To Next Page
Loading...
