Troubleshooting 7 Blinks Failure (TC-P50UT50)
Is the power
LED blinking 7
or 8 times?
8 Times
7 Times
Check the wires between connector P2 on the P board and
SC2 on the SC board. Make sure they are properly seated. If
the problem persists, unplug the TV and remove connector
SC20 from the SC board. Plug-in the TV and turn it on.
Start Here
List of boards likely to cause this symptom. Blink
Code
No.1 No.2 No.3 No.4 No. 5 No. 6
SU SC A Panel 7
Blinks
SD
Unplug the TV and follow step #1 of
the next slide.
Continue on the page after next
Slide 23
Replace the A
board
Find information for TC-P50ST50 on slides 19~22
To Next Page
Loading...
