22
9.2.15. Remove the SS2-Board
1. Disconnect the flexible cables (SS65 and SS67).
2. Remove the screws (×2 ) and remove the SS2-Board.
9.2.16. Remove the BT connector clamper
1. Unlock the cable clampers and the tapes to free the
cables.
2. Remove the claws (×2 ) and remove the BT cable.
3. Disconnect the connector (K1) and remove the A1-K1
cable.
4. Remove the claws (×2 ) and remove the BT connector
clamper.
9.2.17. Remove the Stand bracket plate
1. Remove the Stand bracket fastening screws (×6 , ×2
, ×2 ) and remove the Stand bracket plate.
9.2.18. Remove the M8 nut metals
1. Remove the screws (×2 each) and remove the M8 nut
metals.
9.2.19. Remove the K-Board
1. Remove the screw (×1 ).
2. Disconnect the connector (K1) and remove the K-Board
from the LED panel.
9.2.20. Remove the Contact metal bottom
B
1. Remove the screws (×8 , ×2 ).
2. Remove the Contact metal bottom B.
To Next Page
Loading...
