18
Basic Controls
Remote Control Transmitter
Standby (ON / OFF) button
The Plasma Display must fi rst be plugged
into the wall outlet and turned on at the power
switch (see page 14).
Press this button to turn the Plasma Display
On, from Standby mode. Press it again to turn
the Plasma Display Off to Standby mode.
AUTO SETUP button
Automatically adjusts the position/ size of
the screen.
COMPO. button
Press to select Component or RGB
input. (see page 16)
PC button
Press to select PC input. (see page
16)
HDMI buttons
Press to select HDMI 1 to HDMI 4 input.
(see page 16)
PICTURE button
MENU button
Displays menu screen. (see page 19)
POS. /SIZE button
OK button
Press to make selections.
Cursor buttons
EXIT button
Exits from Menu screen.
FUNCTION buttons
SLOT buttons
Press to select SLOT Terminal Board.
(see page 16)
RETURN button (see page 19)
Press the RETURN button to return to
previous menu screen.
INPUT button
Press to select input signal sequentially.
(see page 16)
ASPECT button
Press to adjust the aspect.
EX.SCALER button
Numeric buttons
MEM. LOAD button
LIGHT button
The remote control’s buttons illuminate.
VIDEO MENU button
Press to select Picture Mode.
Monitor
Normal
Cinema
Dynamic
RECALL button
Press the “RECALL” button to display
the current system status.
1
Input label
2
Aspect mode
During 3D images
Profi le name
NANODRIFT Saver operating
3
Off timer
The off timer indicator is displayed
only when the off timer has been set.
OFF TIMER button
The Plasma Display can be preset
to switch to stand-by after a fi xed
period. The setting changes to 30
minutes, 60 minutes, 90 minutes
and 0 minutes (off timer cancelled)
each time the button is pressed.
30 60
0
90
When three minutes remain, “Off timer
3” will fl ash.
The off timer is cancelled if a power
interruption occurs.
Off timer 90
1
2
3
PC
4:3
Memory name: MEMORY2
NANODRIFT
3D
To Next Page
Loading...
