20
Specifi cations
TH-85VX200W TH-103VX200W
Power Source 200 - 240 V AC, 50/60 Hz
Power Consumption
Power on 1,200 W 1,450 W
Stand-by condition 0.5 W 0.5 W
Power off condition 0.3 W 0.3 W
Plasma Display panel Drive method : AC type
85-inch, 16:9 aspect ratio
Drive method : AC type
103-inch, 16:9 aspect ratio
Screen size 1,889 mm (W) × 1,062 mm (H)
× 2,167 mm (diagonal)
2,269 mm (W) × 1,276 mm (H)
× 2,603 mm (diagonal)
(No.of pixels) 2,073,600 (1,920 (W) ×1,080 (H))
[5,760 × 1,080 dots]
Operating condition
Temperature 0 °C - 40 °C
Humidity 20 % - 80 %
Applicable signals
Colour System NTSC, PAL, PAL60, SECAM, Modifi ed NTSC
Scanning format 525 (480) / 60i · 60p, 625 (575) / 50i · 50p, 750 (720) / 60p · 50p, 1125 (1080) / 60i · 60p · 50i ·
50p · 24p · 25p · 30p · 24sF, 1250 (1080) / 50i
PC signals VGA, SVGA, XGA, SXGA
UXGA ···· (compressed)
Horizontal scanning frequency 15 - 110 kHz
Vertical scanning frequency 48 - 120 Hz
Connection terminals
LAN RJ45 10BASE-T/100BASE-TX, compatible with PJLink™
COMPONENT/RGB IN
Y/G
P
B/CB/B
P
R/CR/R
AUDIO L-R
RCA Pin jack
RCA Pin jack
RCA Pin jack
RCA Pin jack × 2
with sync 1.0 Vp-p (75 Ω)
0.7 Vp-p (75 Ω)
0.7 Vp-p (75 Ω)
0.5 Vrms
PC IN
AUDIO
High-Density Mini D-sub 15 Pin
VBS (use HD port)
Stereo mini jack (M3) × 1
Y or G with sync 1.0 Vp-p (75 Ω)
Y or G without sync 0.7 Vp-p (75 Ω)
P
B/CB/B: 0.7 Vp-p (75 Ω)
P
R/CR/R: 0.7 Vp-p (75 Ω)
HD/VD: 1.0 - 5.0 Vp-p (high impedance)
with picture 1.0 Vp-p (high impedance)
without picture 0.3 Vp-p (high impedance)
0.5 Vrms
AV IN HDMI 1-4 TYPE A Connector × 4
HDMI (Version 1.4 with 3D)
SERIAL External Control Terminal
D-sub 9 Pin RS-232C compatible
3D SHUTTER OUT M3 jack × 1, for 3D IR TRANSMITTER
AUDIO
OUT
L-R RCA PIN JACK × 2 (L / R)
Output level: Variable (-
∞
― 0 dB)
[INPUT 1 kHz / 0 dB, 10 kΩ Load]
Dimensions (W × H × D) 2,015 mm × 1,195 mm × 99 mm 2,412 mm × 1,419 mm × 129 mm
(141 mm when including protruding portion of
terminals)
Mass (weight) approx. 117.0 kg net approx. 199.0 kg net
Notes:
• Design and specifi cations are subject to change without notice. Mass and dimensions shown are approximate.
• This equipment complies with the EMC standards listed below.
EN55022, EN55024, EN61000-3-2, EN61000-3-3.
To Next Page
Loading...
