4747
Using Network Function
This unit has a network function to control the network connected display with your computer.
Note:
To use the network function, set each “Network Setup” setting and make sure to set the “Control I/F Select” to “LAN”.
(see page 41)
Network function is disabled in standby mode.
Network Connection
Notes:
• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.
• Use a LAN cable that is compliant with “CAT5” when connecting a device that supports 100BASE-TX.
• For instructions on how to connect, consult your network administrator.
Example of network connection
Display (main unit, rear)
Hub or broadband router
LAN cable
(Shielded)
ȵ
Use the
Shielded Twist
Pair (STP) LAN
cable.
COMPUTER
To Next Page
Loading...
