25
TH-42LFP30W / TH-47LFP30W
8.13. Removing the cabinet front
1. Remove the cabinet back.
2. Holding the panel mounting brackets, gently lift them up
together with the LCD panel, then the cabinet front will be
released.
• The replacement cabinet front is supplied as a complete
unit of a frame.
Precautions for removing and fitting the LCD panel
• The surface of the LCD panel is covered by an optical filter
(glass). Therefore, the glass protrudes around the LCD
panel. Please exercise adequate care in handling the prod-
uct to avoid bumping or scratching the glass.
8.14. Replacing the Panasonic
badge
• The Panasonic badge is attached on the replacement cabi-
net front, but the Panasonic badge itself can be also sup-
plied as a single part. Take the following steps to replace the
badge
1. Detach the Panasonic badge.
2. Attach the replacement Panasonic badge to the specified
position on the cabinet front as shown in the drawing.
8.15. Replacing the LCD panel
Carry out the following steps to remove the parts attached to
the LCD panel.
1. Remove the cabinet back.
2. Remove the cabinet front.
3. Undo the screws (Model 47V: 8; Model 42: 12) and
remove the panel mounting brackets. (SCR BIN 4X6)
4. Undo 6 screws to remove the chassis base. (SCR BIN
4X6: 4 screws; SCR PAN+SW+W 3X6: 2 screws)
To Next Page
Loading...
