12
Quick start Guide
Cable fixing band
– AC cord fixing
– Cable fixing bands
Secure any excess cables with bands as required.
To secure cables connected to Terminals, wrap the cable fixing band around them then pass the
pointed end through the locking block, as shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress (especially in the
power cord), firmly bind all cables with the supplied fixing band.
To tighten: To loosen:
Pull
Pull
Push the catch
1
Connect power plug to the socket of
the main body.
2
Fix the left clamper.
3
Fix the right clamper.
4
Install the ferrite core.
Ferrite core (Large size)
supplied.
How to fix:
Fix by pushing in till a
clicking sound is heard.
How to release:
Pull up while drawing
the knob.
To Next Page
Loading...
